Calibration

Dot Gain Curves

  • Enable Curve 1: here you can select the reference curve.
  • Enable Curve 2: here you can select the compensation curve.
  • Enable Curve 3: here you can select the bump curve.
Important: The order of the curves is important for processing. The order is shown at the bottom of the window: Application Order: input % > 1 > 2 > 3 > Output %
Note: In some cases the calibration is split up in a plate curve and a press curve. In that case: curve 2 is the press curve and curve 3 is the plate curve including the bump curve.

Calibration Results

Select the disclosure button to reveal this option.

Separation: here you can select a separation from the drop-down list to display its calibration results from the curve settings that are selected in the RIP.